ASSA ABLOY Megadoor VL3110FCS Frequenzgesteuertes Gewebe-Hubtor

Unique ref.: cra_3110_fcs
Marke: ASSA ABLOY Entrance Systems
Produkt Familie: Industrial door, hangar door
Produkt Gruppe: Vertical lifting fabric door
Publishing Datum: 2017-08-29
Versionsnummer: 1
Typ: Objekt (Einzelobjekt)
Das Gewebe-Hubtor ASSA ABLOY VL3110FCS bietet schnelle Leistung in schweren Industrieumgebungen. Es ist die perfekte Wahl , wenn es auf Geschwindigkeit ankommt bei gleichzeitigem Schutz gegen Wind, Nässe und vieles andere.

Einzigartiges Design und Struktur bieten Langlebigkeit, Dichtigkeit, Energieeffizienz, Betriebszuverlässigkeit sowie minimalen Wartungsaufwand. Jedes Gewebe-Hubtor wird individuell auf die besonderen Anwendungsanforderungen zugeschnitten, wie z.B extreme Windlast.

Door leaf
• Door leaf made out of two layers of very strong vinyl-coated polyester fabric, separated by aluminium intermediate sections.
• Intermediate section which gives strength to the door leaf and which creates a buffer between the inside and outside fabric walls.
• Wind load is transferred to the vertical guide rails by the horizontal aluminium sections of the door leaf.
• The door leaf is available in 9 standard colours.
• Door leaf thickness: 100 mm.
• Aluminium guide rails.

Bottom section
• The bottom section, made of steel and aluminium, is connected to the lifting belt via the safety arresters.
• The bottom section contains an optical safety edge and a rubber seal on the bottom edge that creates a seal between the door and the floor.
• Optical safety edge.

Safety arresters and wind lock in stainless steel
• Safety arresters stop the door if the lifting belt becomes slack or, in an unlikely event, would break.
• Wind lock system locks the door when the door is closed.

Surface treatment
• Steel components corrosion treatment: category 3 according to ISO 12944.2. Higher class on request. Aluminium, plastic, stainless steel, zinc electroplated steel (~10u). Fixing elements are mainly hot dip galvanized (FZV). Door leaf screws protected with Geomet.



Door features
• Door range:
MIN: 1810 mm x (no MIN. height)
MAX (W x H): 6000 x 6000 mm (in combination). Other sizes available on request
• Opening speed: up to 1.5 m/sec.
• Temperature range: -35 °C to +70 °C
• Compliance with all operational and safety instructions in EU Directives and the standards of the European Standardisation Committee (CEN)
• Wind load (EN 12424) Class 3-5 (0.7-1.6 kPa, depending on size).
• Water resistance (EN 12425) Class 3, 0.11 kPa (for a closed door).
• Air permeability (EN 12426) Class 2, 12 m3/(m2h).

• Thermal transmittance (EN
12428)

Depending on door size, specific data on request.

• Sound reduction (ISO 717) 15 dB Rw.
• Operating system: Electrical operator

Dimensions:
x mm (WxH)

Options: Door leaf
 Standard: Polyester, 1100 dtex with plasticised PVC coating
 Option: Arctic fabric. For environmental temperatures down to -54°C
 Option: Heat resistant fabric with silicone coating
 Option: Heat resistant fabric with aluminium coating
 Option: Heat resistant fabric with aluminium polyurethane coating
 Option: Sound reduction fabric
 Option: Security fabric

Vision panels
800mm x 800mm
800mm x 1600mm
1300mm x 800mm
1300mm x 1600mm

Fabric color
 Tan (RAL 1001)
 Red (RAL 3001)
 Blue (RAL 5005)
 Green (RAL 6009)
 Grey (RAL 7004)
 Anthracite (RAL 7016)
 White (RAL 9016)
 White aluminium (RAL 9006)
 Translucent white

Header box
 Gear motor on inside of the building
 Gear motor on outside of the building
 Gear motor in the door opening
 Insulated
 Stainless steel cladding and motor casing
 Self-supporting header box



Operator
• Control system PLC-based
• Protection class, control cabinet IP65
• Protection class, safety boxes IP67
• Protection class, motor IP55
• Protection class, brake resistor IP51 (with protection)
• 3/phase 380-480V 50/60Hz power supply
• Control voltage 24V DC
• Fusing: 20 A / 32 A
• Heat and cold resistance, exterior: -35 °C to +70 °C
• Heat and cold resistance, inside control unit: -10 °C to +50 °C
• Power consumption: 2.2 or 4.1 kW

Options
 Radio remote control
 “Open" (during closing process) if open button is used - door immediately stops and opens completely)
 Pull switch for OPEN / CLOSE
 External push-button, key switch
 “One-button function” - opens or closes door, depending on actual status (e.g. radio, pull switch)
 Additional safety (e.g. photo cell, radar) – door immediately opens completely
 Free contacts
 Photo cell
 Reduced opening height
 Radar
 Magnetic loop
 Warning lights
 Emergency power switch
 Interlocking door function

Other supplementary equipment
 Control cabinet in stainless steel
 Heating element in the control cabinet
 Emergency power switch
 Clamp strip covers in the same colors as the fabric
 Side jambs (if posts for installing the guide rails are not available)
 Side jambs in stainless steel
 Wind deflectors (in combination with jambs)


Material 1: Fabric
Material 2: Aluminium
Designed in:
Hergestellt in:

BIMobject Kategorie: Doors - Industrial
IFC Klassifikation: Door
UNSPSC Name: Doors
UNSPSC Code: 301715
Code: JL20
Beschreibung: Doors
Code: PR-59-23-38
Beschreibung: High Speed Doorsets
Code: 59-23-38
Beschreibung: High Speed Doorsets
Dieses Produkt ist verfügbar in:
Africa
  • Algeria
  • Angola
  • Benin
  • Botswana
  • Burkina Faso
  • Burundi
  • Cameroon
  • Cape Verde
  • Central African Republic
  • Chad
  • Comoros
  • Côte d'Ivoire
  • Democratic Republic of the Congo
  • Djibouti
  • Equatorial Guinea
  • Eritrea
  • Ethiopia
  • Gabon
  • Ghana
  • Guinea
  • Guinea-Bissau
  • Kenya
  • Lesotho
  • Liberia
  • Libya
  • Madagascar
  • Malawi
  • Mali
  • Mauritania
  • Mauritius
  • Mayotte
  • Morocco
  • Mozambique
  • Namibia
  • Niger
  • Nigeria
  • Republic of the Congo
  • Reunion
  • Rwanda
  • Saint Helena
  • São Tomé and Príncipe
  • Senegal
  • Seychelles
  • Sierra Leone
  • Somalia
  • South Africa
  • South Sudan
  • Sudan
  • Swaziland
  • Tanzania
  • The Gambia
  • Togo
  • Tunisia
  • Uganda
  • Western Sahara
  • Zambia
  • Zimbabwe
Europe
  • Åland Islands
  • Albania
  • Andorra
  • Austria
  • Belarus
  • Belgium
  • Bosnia and Herzegovina
  • Bulgaria
  • Croatia
  • Cyprus
  • Czech Republic
  • Denmark
  • Estonia
  • Faroe Islands
  • Finland
  • France
  • Germany
  • Gibraltar
  • Greece
  • Guernsey
  • Hungary
  • Iceland
  • Ireland
  • Isle of Man
  • Italy
  • Jersey
  • Latvia
  • Liechtenstein
  • Lithuania
  • Luxembourg
  • Macedonia (FYROM)
  • Malta
  • Moldova
  • Monaco
  • Montenegro
  • Netherlands
  • Norway
  • Poland
  • Portugal
  • Romania
  • Russia
  • San Marino
  • Serbia
  • Slovakia
  • Slovenia
  • Spain
  • Svalbard and Jan Mayen
  • Sweden
  • Switzerland
  • Ukraine
  • United Kingdom
  • Vatican City
Middle East
  • Afghanistan
  • Bahrain
  • Egypt
  • Iran
  • Iraq
  • Israel
  • Jordan
  • Kuwait
  • Lebanon
  • Oman
  • Palestine
  • Qatar
  • Saudi Arabia
  • Syria
  • Turkey
  • United Arab Emirates
  • Yemen

AEC Daily

AEC_Daily_Links

AEC_Daily_Links

Powered by BIMobject®