CE mark acc. to DIN EN 13241-1
Glazing frames made of aluminium extrusion profiles with steel end caps, bottom section made of double-skinned PU-foamed steel section, made of hot-galvanized sheet steel. Inner and outer finger trap protection. With bottom seal, intermediate seals and lintel seal made of EPDM, depth 42 mm.
Glazing frames with clear synthetic double panes, 26 mm. Optionally further infills on request.
Exterior and interior of glazing frames anodised in E6/C0 DIN 17611. Exterior and interior of bottom section polyester primer-coated, coil coating based on RAL 9002 Grey white. Exterior S-ribbed, Stucco-textured with horizontal ribbing with a spacing of 125 mm, interior Stucco-textured. Optionally glazing frames and bottom section in 10 preferred colours, RAL to choose, metallic colours, British Standard or NCS colours on request.
Angle frame with side trap guard, made of hot-galvanized sheet steel, horizontal safety tracks, side seal made of EPDM.
Counterbalance via torsion springs, min. 25,000 door cycles (standard). Optionally stronger torsion springs (more door cycles) on request.
Operator WA 400 with control A445. Optionally further model variants (operators/controls) on request.
Professional fitting of a door incl. wiring as well as adjustment/alignment and test run on an existing base construction that is suitable for fitting the door.
The floor in the area of the door opening must be horizontal across the entire door width. The exterior floor should be inclined away from the door directly in front of the door curtain.
Application areas: Logistics, commercial halls, industrial halls, warehouses, workshops, collective garages