Litex Membrane under Concrete on all surfaces

LITEX MEMBRANE UNDER CONCRETE ON ALL SURFACES

Litex Membrane has Technical Approval from SINTEF Byggforsk and is used both for new buildings and for renovation.

SUBSTRATE
Litex Membrane can be laid on any solid surface.

LITEX MEMBRANE PROTECTION
One layer of Litex Membrane Protection is applied over the Litex Membrane to protect the membrane during casting. NB! When concrete is the surface, Litex Membrane Protection is also used under the Litex Membrane.

LITEX MEMBRANE
Litex Membrane is applied underneath with or without floor heating. The assembly is done in one operation.
The Litex Membrane is applied with a minimum of 80 mm overlap at the joints. Then perform spot welding, pre-welding and main welding with hot air gun. Remember to check the joints.

Take into account that the membrane is installed vertically at minimum of 50 mm above the highest point on the finished floor surface. Litex Internal and External corners must be used. Remember to check the joints.

CONCRETE LEVELLING
After the protective layer is laid, the floor can be levelled so that a fall can be established.

ENVIRONMENTALLY FRIENDLY
At Litex, we care about indoor climate and the environment. The products in the Litex Membrane System contain no brominated flame retardants or other environmental toxins that can harm you or your family.

The products in the Litex Membrane System can be delivered to a regular waste disposal site for recycling.

#wet room #bathroom #laundry room #membrane #wet room membrane #wet room system